Posted by AlexF on April 19, 2009, 2:49 am
I am in the middle of stripping down and restoring an Atco 'Fourteen'
mower.
Most of the parts (even the rusted ones) have come off without
too much trouble
however I need some advice on two points.
1. How do I remove the blade cassette? It is not the newer QX type, and
I just
can't see how it comes out. Any ideas...
2. The Exhaust Pipe is totally rusted in and I cannot get it out. I've
had is
soaked in WD40 for a few days now but it still will not budge.
Thanks in advance
Alex
--
AlexF
Posted by Chuck on April 19, 2009, 9:25 am
AlexF wrote:
> I am in the middle of stripping down and restoring an Atco 'Fourteen'
> mower. Most of the parts (even the rusted ones) have come off without
> too much trouble however I need some advice on two points.
>
> 1. How do I remove the blade cassette? It is not the newer QX type, and
> I just can't see how it comes out. Any ideas...
>
> 2. The Exhaust Pipe is totally rusted in and I cannot get it out. I've
> had is soaked in WD40 for a few days now but it still will not budge.
>
> Thanks in advance
>
> Alex
>
>
>
>
Try heat?
XML site map
> mower. Most of the parts (even the rusted ones) have come off without
> too much trouble however I need some advice on two points.
>
> 1. How do I remove the blade cassette? It is not the newer QX type, and
> I just can't see how it comes out. Any ideas...
>
> 2. The Exhaust Pipe is totally rusted in and I cannot get it out. I've
> had is soaked in WD40 for a few days now but it still will not budge.
>
> Thanks in advance
>
> Alex
>
>
>
>