|
Posted by Joe on June 25, 2008, 8:01 am
If you were Registered and logged in, you could reply and use other advanced thread options
> Have an irrigation well with 30' depth, 2" pump input and check valve, 1.5hp
> pump. This setup has delivered great water for the system. Saturday, the
> pump ran but nothing coming out. Went ahead and primed it, but no output.
> The guy that dug the well said "well, it's either a bad pump, a bad check
> valve, or I need to go back and maybe move the plug back down.
>
> Monday, I took the pump to local pump shop. They told me yesterday nothing
> was wrong. Although I've not heard of a bad check valve, I'm going to
> change it today.
>
> Any thoughts on where our problems are? Am I missing anything?
>
>
when you prime it does the water stay at the level you fill it to or
does it drain out? if it slowly drains back down it is the check valve
or a leak in the pipe. if you are in drought conditions maybe the water
level has dropped and you need to extend the suction pipe to get it back
in the water. can you look in to see where the water level is in
relation to the suction pipe. may need flashlite.
| 
XML site map