ATCO 12/36 lawn tractor help needed

 
Hi all I am currently restoring an ATCO 12/36 lawn tractor and need some
help regarding the belt drive for the collector brush.  If anyone can
supply photos of the drive belt between the tractor and the brush it
would be very useful also the size/identification numbers from this
belt. This is the only part now not working as I cant figure out how the
belt changes from a horizontal to vertical drive.


Thanks in advance.




--
oldyellow

 

Perhaps this will help:
http://www.mtmc.co.uk/Atco-TRACTOR-12/36-/-F016L80188-/-230-Volt-Spare-Parts__p-23971.aspx

 
Brooklyn1;915346 Wrote:

Thanks I already have that site and it shows ALMOST everything but does
not show the arrangement for the rear drive belt for the brush




--
oldyellow

 
oldyellow;915334 Wrote:

I have the same mower the size on the belt is a A 1100 mines keeps
jumping of at the moment so I am going to try the next size down it did
work last year with that size but something jammed the brush and the
belt started slipping after that as to fitting it my mower has the route
on the flap that covers the belt if not when it comes of the top of the
pulley on the collector it goes round the spring loaded top pulley then
across to the drive pulley front side then returns to spring loaded
bottom pulley again to the front side with a twist in it to return to
the bottom side of the collector pulley hope this helps if not let me
know and i could send a photo of it




--
jimednie