Posted by Peter Ryan on May 1, 2005, 9:11 am
I have just bought a secondhand Victa lawnmower which goes fine.
However, could someone give me some help on the proper ratios for mixing in
two stroke oil with petrol.
The Victa website recommends 50:1 (50 parts unleaded fuel to 1 part oil) for
Victa's high performance "Formula V" oil, and 25:1 for other 2-stroke oils.
Any advice or shortcuts will be appreciated.
Cheers
Peter
Posted by len gardener on May 1, 2005, 1:49 pm
g'day peter,
not sure about victas own brand label formula v oil, sounds like a
synthetic type oil. in general with some machinery it is best you use
their recommended oil.
for me i have always used castrol 2t, but then i don't use engines
like victa's or mccullochs etc.,.
but at the end of the day get into the habit of only mixing your 2
stroke fuel as you need it. i use one of those fish morney jars
calibrated to .5 a litre, and use a medicine galss to measure the oil.
at 50:1 that is 10ml of oil for the 500ml of fuel, measure out the
fuel before adding the oil at all times.
on the other side of it i ahve written my impression non scientific or
engineered about the recommended use of 50:1 oils in modern engines,
just how i see it from waht i knew around 25 years ago and it was that
long ago that victa knew 2 strokes where going to come under the epa
spotlight. look on my mower page.
and as a for example to support my story i have a shindaiwa
brushcutter that is recommended to run on 50:1 of any sort of oil (and
remember manufacturers of machines don't make oils they get them from
oil blending companies like castrol etc.,.) anyhow the shindaiwa is a
lot heavier on fuel than was my old jonsered 22cc shind' 27cc the fule
use is huge like driving and old v8 (non adjustable carbies these days
epa reg's 'n all). my theory being ok superficially they cut down the
amount of oil to make 2 strokes appear clean but run them richer to
make sure that the engine gets enough oil for lubing purposes. anyhow
you can read it in my story.
the point to remember once outside the warranty period most all of us
do not have the resources to prove that built in obsolesance isn't the
prime factor, in using 50:1.
len
snipped
--
happy gardening
'it works for me it could work for you,'
"in the end ya' gotta do what ya' gotta do" but consider others and the
environment
http://members.optusnet.com.au/~gardenlen1/
my e/mail addies have spam filters you should know what to delete before you
send.
Posted by Peter Ryan on May 1, 2005, 6:41 pm
many thanks for the info peter
> g'day peter,
> not sure about victas own brand label formula v oil, sounds like a
> synthetic type oil. in general with some machinery it is best you use
> their recommended oil.
> for me i have always used castrol 2t, but then i don't use engines
> like victa's or mccullochs etc.,.
> but at the end of the day get into the habit of only mixing your 2
> stroke fuel as you need it. i use one of those fish morney jars
> calibrated to .5 a litre, and use a medicine galss to measure the oil.
> at 50:1 that is 10ml of oil for the 500ml of fuel, measure out the
> fuel before adding the oil at all times.
> on the other side of it i ahve written my impression non scientific or
> engineered about the recommended use of 50:1 oils in modern engines,
> just how i see it from waht i knew around 25 years ago and it was that
> long ago that victa knew 2 strokes where going to come under the epa
> spotlight. look on my mower page.
> and as a for example to support my story i have a shindaiwa
> brushcutter that is recommended to run on 50:1 of any sort of oil (and
> remember manufacturers of machines don't make oils they get them from
> oil blending companies like castrol etc.,.) anyhow the shindaiwa is a
> lot heavier on fuel than was my old jonsered 22cc shind' 27cc the fule
> use is huge like driving and old v8 (non adjustable carbies these days
> epa reg's 'n all). my theory being ok superficially they cut down the
> amount of oil to make 2 strokes appear clean but run them richer to
> make sure that the engine gets enough oil for lubing purposes. anyhow
> you can read it in my story.
> the point to remember once outside the warranty period most all of us
> do not have the resources to prove that built in obsolesance isn't the
> prime factor, in using 50:1.
> len
> snipped
> --
> happy gardening
> 'it works for me it could work for you,'
> "in the end ya' gotta do what ya' gotta do" but consider others and the
environment
> http://members.optusnet.com.au/~gardenlen1/
> my e/mail addies have spam filters you should know what to delete before
you send.
Posted by Mitch McCreath on May 1, 2005, 4:15 pm
> I have just bought a secondhand Victa lawnmower which goes fine.
> However, could someone give me some help on the proper ratios for mixing
in
> two stroke oil with petrol.
> The Victa website recommends 50:1 (50 parts unleaded fuel to 1 part oil)
for
> Victa's high performance "Formula V" oil, and 25:1 for other 2-stroke
oils.
> Any advice or shortcuts will be appreciated.
> Cheers
> Peter
Peter,
The correct ratio is 25:1
( I have the serice manual for 2 stroke Victas)
(Has come in handy!!)
40 ml of a vegetable based oil to 5 litres of unleaded.
Easiest way to mix the oil.
When you go to get the can refilled you can buy a little container
of 2 stroke oil (40ml). Put that in the can then go add the petrol.
Done easy.
Regards,
Mitch................
Posted by Peter Ryan on May 1, 2005, 6:42 pm
thanks mitch
> > I have just bought a secondhand Victa lawnmower which goes fine.
> >
> > However, could someone give me some help on the proper ratios for mixing
> in
> > two stroke oil with petrol.
> >
> > The Victa website recommends 50:1 (50 parts unleaded fuel to 1 part oil)
> for
> > Victa's high performance "Formula V" oil, and 25:1 for other 2-stroke
> oils.
> >
> > Any advice or shortcuts will be appreciated.
> >
> > Cheers
> >
> > Peter
> Peter,
> The correct ratio is 25:1
> ( I have the serice manual for 2 stroke Victas)
> (Has come in handy!!)
> 40 ml of a vegetable based oil to 5 litres of unleaded.
> Easiest way to mix the oil.
> When you go to get the can refilled you can buy a little container
> of 2 stroke oil (40ml). Put that in the can then go add the petrol.
> Done easy.
> Regards,
> Mitch................
> not sure about victas own brand label formula v oil, sounds like a
> synthetic type oil. in general with some machinery it is best you use
> their recommended oil.
> for me i have always used castrol 2t, but then i don't use engines
> like victa's or mccullochs etc.,.
> but at the end of the day get into the habit of only mixing your 2
> stroke fuel as you need it. i use one of those fish morney jars
> calibrated to .5 a litre, and use a medicine galss to measure the oil.
> at 50:1 that is 10ml of oil for the 500ml of fuel, measure out the
> fuel before adding the oil at all times.
> on the other side of it i ahve written my impression non scientific or
> engineered about the recommended use of 50:1 oils in modern engines,
> just how i see it from waht i knew around 25 years ago and it was that
> long ago that victa knew 2 strokes where going to come under the epa
> spotlight. look on my mower page.
> and as a for example to support my story i have a shindaiwa
> brushcutter that is recommended to run on 50:1 of any sort of oil (and
> remember manufacturers of machines don't make oils they get them from
> oil blending companies like castrol etc.,.) anyhow the shindaiwa is a
> lot heavier on fuel than was my old jonsered 22cc shind' 27cc the fule
> use is huge like driving and old v8 (non adjustable carbies these days
> epa reg's 'n all). my theory being ok superficially they cut down the
> amount of oil to make 2 strokes appear clean but run them richer to
> make sure that the engine gets enough oil for lubing purposes. anyhow
> you can read it in my story.
> the point to remember once outside the warranty period most all of us
> do not have the resources to prove that built in obsolesance isn't the
> prime factor, in using 50:1.
> len
> snipped
> --
> happy gardening
> 'it works for me it could work for you,'
> "in the end ya' gotta do what ya' gotta do" but consider others and the